TTP224 - 4 Channel Digital Touch Sensor Module
158,12 AZN
SPECIFICATIONS
- Operating Voltage: 2V-5.5V
- Startup Calibration Delay: 0.5 Sec
- Simple to Use, Auto Calibration
- Output Status Indicator LED
- Output can be configured be Active High or Low
- Output Mode can be configured to Toggle or Momentary
- Output can be directly connected to Microcontroller's Input pins
PRODUCT DESCRIPTION
To connect it with Arduino, connect Pins VCC and GND to power up the module. Connect the Output pins to any Digital I/O pins of the Microcontroller Board. Whenever the user touches the pad the corresponding LED will light up and the pin will go High. You can read this signal by using the Digital Read command.